Meinberg LANTIME M600 Technical Information download pdf (Page 83)

The Command Line Interface

The command line interface (CLI) can be used within a TELNET or SSH session.

After login, just enter “setup” to start the CLI setup tool.

The start page gives a short overview of the most important configuration parameters

and the runtime statistics of the unit. In the upper left corner you can read which

LANTIME type and version of the LANTIME software you are using. This

LANTIME software version is a head version number describing the base system and

important subsystem. Below the version you will find the actual hostname and

domain of your LANTIME unit, the IPv4 and IPv6 network address of the first

network interface and on the right side the serial number, the uptime of the system

(time since last boot) and the notification status is reported.

In the second section the actual status of the GPS reference clock and the NTP

subsystem is shown, additional information about the GPS receiver can also be found

here. This includes the number of satellites in view and the number of good satellites

in view.

The third section shows the last messages of the system, each with a timestamp

added. The newest messages are placed at the top of the list. This reflects the content

of the file /var/log/messages, which is created after every start of the system (and is

lost after a power off or reboot, see “Syslog server” to learn how to save the entries of

your SYSLOG).

By using the buttons in the lower part of the screen, you can reach a number of

configuration pages, that are described below.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 150 151

No comments

Meinberg LANTIME M600 Technical Information Page 83