Meinberg LANTIME M600 Technical Information download pdf (Page 40)

Setup Network Interfaces

Setup Network Ipv4 Parameter

There is a separate configuration submenu for every physical network interface. If

there is no DHCP client mode activated a static IP address for each interface can be

entered. IPv4 addresses are built of 32 bits which are grouped in four octets, each

containing 8 bits. You can specify an IP address in this mask by entering four decimal

numbers, separated by a point “.” .

Example: 192.168.10.2

Additionally you can specify the IPv4 netmask and your default gateway address.

Please contact your network administrator, who can provide you with the settings

suitable for your specific network.

If there is a DHCP (Dynamic Host Configuration Protocol) server available in your

network, the LANTIME system can obtain its IPv4 settings automatically from this

server. If you want to use this feature (again, you should ask your network

administrator whether this is applicable in your network), you can change the DHCP

Client parameter to “ENABLED”. Using DHCP is the default factory setting.

If the DHCP client has been activated, the automatically obtained parameters are

shown in the appropriate fields (IPv4 address, netmask, gateway).

-> Ipv4 Parameter <- Link Mode

Ipv6 Parameter

Global Cfg. Services

-> Interfaces <-

>DHCP: disabled< ADDR: 192.168.10.2

NETMASK: 255.255.255.0

-> ETH0 <- Def.Gateway

ETH1

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 150 151

No comments

Meinberg LANTIME M600 Technical Information Page 40