Meinberg LANTIME M600 Technical Information download pdf (Page 42)

Menu: Setup Services

The possible network protocols and access methods can be configured. After

pressing the OK button you can enable/disable SSH, TELNET, SNMP, FTP, IPV6,

HTTP, HTTPS and NETBIOS by using the UP/DOWN Keys and navigate through

the list with the LEFT/RIGHT keys. After you saved your settings with the “OK”

button, all these subsystems are stopped and eventually restarted (only if they are

enabled, of course).

Menu: System

In this submenu system specific parameters can be configured.

With Set time zone the time zone displayed on the front panel display can be

configured (see below).

With Restart NTP you can stop the currently running NTP daemon and restart it

afterwards.

The command Reboot time server reboots the Linux operating system

– the build-in reference clock will not be restarted.

When Reset to factory defaults is called, all system parameters will be reset to

initial values. However the parameters of each network interface do not change.

Set time zone

The time zone of the time that is shown on the front panel display can be set up

here. The internal time zone of the timeserver and the time of NTP will always be

UTC. These parameters will not affect the serial output lines and the timecode (IRIG)

outputs. These parameters have to be configured in another menu

(Reference Time->Setup Outputs)

>SSH:on < TELN:on IPv6:on HTTPS:on

FTP:on SNMP:off HTTP:on NETB:off

Global Cfg. -> Services <-

Interfaces

Reference Time Network

Time Service -> System <-

->Set Time Zone<- Restart NTP

Reboot Server Factory Defaults

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 150 151

No comments

Meinberg LANTIME M600 Technical Information Page 42